Functional Description; Switch Action; Speed Adjusting Dial - Makita 2107F Manual De Instrucciones

Ocultar thumbs Ver también para 2107F:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

9.
When cutting metal, be cautious of hot flying
chips.
10. Do not leave the tool running unattended.
11.
Do not touch the blade or the workpiece
immediately after operation; they may be
extremely hot and could burn your skin.
12. Hold power tools by insulated gripping
surfaces when performing an operation where
the cutting tool may contact hidden wiring or
its own cord. Contact with a "live" wire will make
exposed metal parts of the tool "live" and shock
the operator.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
Symbols
The followings show the symbols used for tool.
volts
amperes
hertz
alternating current
no load speed
Class II Construction
revolutions or reciprocation per minute

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
unplugged before adjusting or checking function on
the tool.

Switch action

006189
CAUTION:
USD201-2
Before plugging in the tool, always check to see
that the switch trigger actuates properly and returns
to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and then
push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.

Speed adjusting dial

005896
The tool speed can be infinitely adjusted between 1.0
m/s and 1.7 m/s by turning the adjusting dial. Higher
speed is obtained when the dial is turned in the direction
of number 5; lower speed is obtained when it is turned in
the direction of number 1.
Select the proper speed for the workpiece to be cut.
CAUTION:
The speed adjusting dial can be turned only as far
as 5 and back to 1. Do not force it past 5 or 1, or the
speed adjusting function may no longer work.
4
1
1. Lock button
2. Switch trigger
2
1. Speed adjusting
1
dial

Publicidad

Tabla de contenido
loading

Tabla de contenido