Declaration Of Conformity - NEC NP01SW Serie Manual De Instalación

DOC Compliance Notice (for Canada only)
This Class B digital apparatus complies with Canadian ICES-003.
RF Interference (for USA only)
WARNING
The Federal Communications Commission does not allow any modifications or changes to
the unit EXCEPT those specified by NEC Display Solutions of America, Inc. in this manual.
Failure to comply with this government regulation could void your right to operate this equip-
ment. This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio / TV technician for help.
WARNING TO CALIFORNIA RESIDENTS:
Handling the cables supplied with this product will expose you to lead, a chemical known to
the State of California to cause birth defects or other reproductive harm. WASH HANDS AF-
TER HANDLING.
This device complies with Part 15 of FCC Rules. Operation is subject to the following two
conditions. (1) This device may not cause harmful interference, and (2) this device must ac-
cept any interference received, including interference that may cause undesired operation.
U.S.Responsible Party:
Address:
Tel. No.:
Type of Product:
Equipment Classification: Class B Peripheral
Model No.:
We hereby declare that the equipment specified above conforms to the technical
standards as specified in the FCC Rules.

DECLARATION OF CONFORMITY

NEC Display Solutions of America, Inc.
500 Park Boulevard, Suite 1100
Itasca, Illinois 60143-1248
(630) 467-3000
Interface selector
NP01SW
ENG-6