Toasting; Using The Bun Warmer; Faults And Troubleshooting - Beem Blue Touch 4+ Manual De Instrucciones

REHEATING TOAST
This function allows you to reheat toasted bread. Start toasting as normal. Then
push the function button. The button then lights up as well. Reheating can be
ended with the Cancel button at any time.
CANCEL
You can end toasting at any time by pressing this button. The toast is then
ejected again normally.
6.1

Toasting

1. Put the plug in a socket.
2. Insert the desired number of slices of bread, bagels etc. in the slots.
3. Set the desired browning level. Level 1 browns least level 9 produces the darkest
toast.
4. Press the start button.
The toasting begins and the status display lights up completely. All the status lamps
go out gradually until toasting finishes.
NOTE: You can end toasting at any time by pressing the
5. The toaster automatically ejects the toast when it is ready.
6. Remove the bread from the toast slots.
NOTE: If it is not brown enough, toast the bread again on a lower setting. Keep
an eye on the toaster to make sure the bread does not burn.
ATTENTION: If the toast should get jammed, pull out the mains plug and let the
toaster cool down. Remove the toast carefully to avoid damaging the toasting
slots.
7. Clean the toaster regularly as described in chapter 8.
6.2

Using the bun warmer

The separate bun warmer can be used to heat up cakes, croissants, bagels etc.
1. Place the bun warmer horizontally on the toasting slots.
2. Select a low to medium browning level.
3. Press the start button.
4. Stop the toasting procedure using the
programme.
7.

Faults and troubleshooting

Faulty function
Indicator lights do
not come on
Fuse blows
BEEM – Elements of Lifestyle
Possible reason
Mains plug not plugged in
No electricity supply
Utensil is faulty
Too many appliances connected
button or wait until the end of the
Remedy
Connect the utensil to the
mains
Check the fuse/plug
Inform the after-sales service
Reduce number of appliances
using the circuit
button.
15/48