Cleaning And Maintenance - Bimar PSK1A Manual De Instrucciones

Fax +32 030 9904733

Practical advice:
•
Show your pet the brush kit while it is connected to the vacuum cleaner, and give it time to see it
and smell it.
•
When first using the kit, brush your pet with the brush and vacuum hose connected but without
turning on the device.
•
Turn the vacuum on at the lowest setting, so that your pet can get used to the noise.
•
Brushing in short periods that your pet is not stressed while the brush is in operation. The aim is
to make it enjoyable as if it is a special type of stroking just for him.
•
The well-being of your pet is the most important thing.

CLEANING AND MAINTENANCE

Warning: before cleaning the brush, disconnect it from the hose.
• Brush: this need to be cleaned thoroughly after each use to avoid build up of dandruff, hair, dirt
between the bristles. Wash the brush using a regular toothbrush with warm water and ordinary
household washing-up liquid, then rinse with plenty of water, and dry thoroughly.
• The hose must only be cleaned with a soft cloth that has been slightly dampened either with just water
and/or detergent. It cannot be washed in the dishwasher. Dry carefully and completely before using it
again.
• If you decide to no longer use the kit, it is recommended that to remove any parts that could represent
a risk to playing children.
• At the end of its lifespan, the kit must not be disposed of as part of ordinary waste.
It can be handed in to specific collection points set up by the municipality, or to retailers who provide
such a service.
Separate disposal prevents negative consequences to the environment and health caused by
inappropriate disposal. It allows for the materials it is made of to be recycled so as to save energy and
resources.
Incorrect disposal of the kit by the user will lead to administrative sanctions according to current
regulations.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
7/16
Assembly page 7/16