Installation Instructions - Rimax RB205 Manual De Instrucciones

Installation Instructions

Monitor Unit System
1. Raise the hanging buckle, remove
the battery cover (as shown in Figure 1),
and then put in the li-ion battery, make
sure the battery contacts are well
connected to the metal contact points
on the chassis, then close the battery cover
2. Use the supplied transformer
(as shown in Figure 2), connect
It to the transformer outlet of the
Monitor vision system and the
other end to the power supply.
3. The system will automatically
enter into charging mode.
[the green display indicator will automatically light up].
When using the BM0305 for the first time, it is important to charge
the unit for at least 4 hours until the
monitor unit system is off, the monitor can also be charged. The green
display indicator will light up while charging and will go off after the
charging is has been completed.
4. Press ON/OFF button to start the monitor unit.
.
charging process is
23
Figure 1
Figure 2
over. If the