Humidity Control - Carrier idealday 18 Manual De Instrucciones

GB ON/OFF
ENGLISH
On/Off Button and
The unit is switched on and off by pressing the
O /O
N FF BUTTON
display.
FAN SPEED
Fan Speed Control
The dehumidifier features a two speed fan control.
As soon as the unit is switched on, the fan will
automatically start running in low speed, indicated by
the -symbol [2] on the display.
By depressing the
back and forth between high fan speed
fast operation and low fan speed
operation.

HUMIDITY CONTROL

Relative humidity setting [1] and [3]
The display on the control panel indicates the actual
relative humidity level in the air.
As soon as the unit is switched on by the O
, the indicator
BUTTON
automatically set on continuous running.
By depressing the
from a range of relative humidity settings [1].
Generally, we feel most comfortable when the
setting is between 50% – 60%. Select your preferred
humidity level and the unit will run until the moisture
in the room reaches the desired level. From then on it
will cycle on and off to maintain the level chosen.
If is selected, the dehumidifier will run
CONT
continuously irrespective of how dry the air becomes.
Comfort dehumidify [a] - idealday 23 only
Repeatedly pressing the
the setting (see [1])
COMFORT HUMIDITY
indicator light [a] will illuminate.
The relative humidity level maintained by the comfort
mode is related to the room temperature:
- below 20 °C the RH will be set to 60%;
- between 20 °C and 27 °C the RH will be maintained
between 50% and 60%;
- above 27 °C the humidity will be kept at 50%.
CLOCK
24 hour clock [B] time setting procedure.
Press the
TIMER BUTTON
the left will blink indicating that the hours setting can
be changed. Repeatedly press the
until the correct hour is shown.
Press the
TIMER BUTTON
blink indicating that the minutes setting can be
changed. Repeatedly press the
the correct minutes are shown.
Press the
TIMER BUTTON
GB-3
[3]
. The -symbol [3] will appear on the
, you can switch
SPEED BUTTON
[2] for quiet
will come on and the unit is
CONT
or , you can choose
BUTTON
or scrolls round
BUTTON
to 50% 60% 70% 80% and to
CONT
. In this last mode the comfort mode
for 2 seconds. The 2 digits on
or
, the 2 digits on the right will
or
BUTTON
, the time is now set.
TIMER
ON-timer – when the unit is OFF
To set the time when the unit must start – in the
mode it was last running in.
Press the
on the left will blink indicating that the hours setting
can be changed. Repeatedly press the
until the required hour when the unit is to
BUTTON
start ("come on") is shown.
Press the
blink indicating that the minutes setting can be
changed. Repeatedly press the
the required minutes are shown.
The indicator light
[2] for
display [4] indicate that the
OFF-timer – when the unit is ON
To set the time when the unit must stop running.
Press the
on the left will blink indicating that the hours setting
can be changed. Repeatedly press the
until the required hour when the unit is to
BUTTON
/O
N FF
stop running ("go off") is shown.
Press the
blink indicating that the minutes setting can be
changed. Repeatedly press the
the required minutes are shown.
The indicator light
[4] indicate that the
/ will indicate if one or both timers are set.
ON OFF
Press the
setting and follow the same procedure as above.
After 20 seconds the timer
illuminate and the 4-digits display will show the
actual time. The unit will now automatically come
on and go off at the set times, until the timer
programming is cancelled.
Cancelling the timer programming When the
is next pressed, the timer programming is
BUTTON
cancelled and the timer on/off indicators will go out.
WATER CONTAINER FULL
Water full indicator light (c) and
When the water container is full, the
indicator light (c) will illuminate (the display will
FULL
show
It will also beep several times to advise you that the
container is full. See instructions for emptying the
water container.
BUTTON
The
WATER CONTAINER FULL
illuminate and the unit will beep if the water
container has not been inserted properly or if it has
been removed. Once the water container is emptied
until
and replaced correctly, the unit will re-start.
whilst the unit is off. The 2 digits
TIMER BUTTON
, the 2 digits on the right will
TIMER BUTTON
or
[b] and the
TIMER ON
TIMER ON
whilst the unit is on. The 2 digits
TIMER BUTTON
, the 2 digits on the right will
TIMER BUTTON
or
[b] and the
TIMER OFF
has been set.
TIMER OFF
twice to enter a second timer
TIMER BUTTON
/ indicators will
ON OFF
[5]) and the unit will automatically shut off.
indicator light will also
or
until
BUTTON
on the
has been set.
or
until
BUTTON
on the display
TIMER
[5]
WATER CONTAINER