Cleaning And Maintenance - Perel Tools CFAN0325N Manual Del Usuario

4. Features
 2 speed settings
 smooth oscillation for an effective cooling
 oscillation can be turned off
 soft touch buttons
 with handle - portable
5. Overview
Refer to the illustrations on page 2 of this manual.
1 grille mounting screw
2 front grille
3 fan blade
4 fan blade mounting nut
5 rear grille
6. Assembly
Assemble the fan as follows:
1. Loosen the grille mounting nut from the motor housing.
2. Position the rear grille firmly to the motor housing. Fasten it with the mounting nut.
3. Push the fan blade along the motor shaft.
4. Hang the front grille on the rear grille using the grille clamp. Fix the grilles together with the clips on the
rim of the front grille. Fix with the screw and nut.
Your fan is now ready for use.
7. Use
To use the fan:
1. Place the fan on a flat and sturdy surface. Make sure no objects (e.g. curtains) can be sucked into the rear
of the fan.
2. Insert the power plug into the mains.
3. Set the desired output speed using the speed buttons: 0 = stop; 1 = low; 2 = high.
4. Push down the oscillation knob to make the fan oscillate. Pull up the oscillation knob to fix the fan's
direction.
5. Always switch off and unplug from the mains before moving the fan.
6. Switch off and unplug from the mains after use.
8.

Cleaning and maintenance

 Disconnect the device from the mains prior to maintenance activities.
 Clean out the parts with a soft and dry cloth. Remove stains with a damp cloth and some mild soap.
Remove soap remnants with the damp cloth. Do not use abrasives.
 Make sure no water or any other liquid enters the motor assembly or the control buttons.
 Keep the ventilation holes of the motor assembly free from dust at all times.
V. 02 – 13/01/2016
CFAN0325N
6 grille mounting nut
7 oscillation knob
8 stand
9 feet
4 ©Velleman nv