OK. OBH 26321 Manual De Instrucciones página 18

EN
Place the cooktop centered into the cutout of working plate. The sealing strip is already adhered to
4
the underside of the cooktop field. The edge of the working plate must be smooth and flat, so that
the hob seats solidly and the sealing strip provides sufficient seal between cooktop and working
plate.
Note:
If the working plate is not smooth, e.g. tiled you need to fill the gaps or joints in the support area of
the seal.
WARNING! Make sure the power cord is not kinked, squeezed or laid over sharp edges. The cable
must be guided to the connection so that it does not touch hot parts of the hob or oven.
5 Mount the four brackets with the screws (4 x brackets and 4 x screws included) from the bottom.
The brackets must be turned into correct position according to the thickness of the board.
TIPS FOR SELECTION OF POTS / PANS
• Only use pots/pans with flat bottoms, to avoid damaging the hot plate.
6
• Only use pots/pans, with same or similar size as hotplate to prevent heat loss.
• Always lift pots or pans before moving on the cooktop in order to avoid scratches on the glass.
OPERATION
Conventional use
Turn on cooktop by pushing ON/OFF switch
7
Put the pot with food on the desired hob.
8
Note: The pot must be clean and dry outside. Do not turn on the product if there is no pot/pan
placed on the hob.
Push + or – of the desired hotplate to adjust the power level. Follow the symbols
above the power level displays in order to operate the correct hotplate.
Note:
• Default setting is power level 5
• If no settings are done at the hotplates are done within one minute after switching ON the
cooktop the product will turn OFF.
• Power level settings can be changed at any time during cooking by using buttons +/–.
When the cooking process is finished, turn off the respective hotplates by touching the – button
9
until " -- " is shown in display or by touching + and – at once.
10 To switch OFF the cooktop completely touching the switch
Note: The cooktop is provided with automatic power off function. This will automatically switch off
hotplates when they are switched ON without changes about several hours. The power OFF times
are shown in following table:
Power level
Power off time (h) 8
Note: The cooktop is provided with a temperature sensor and overheat protection in order to
switch OFF hotplates in case of overheating.
IM_OBH26321_141126_V08_HR.indb 18
1 2 3 4
8 8 4
18
. The displays for power level show --.
.
5 6 7
4 4 2
/ / /
8 9
2 2
26/11/14 9:54 AM