Fagor BC-275 Manual De Instrucciones página 9

a) in grams
b) in lb:oz
c) in fl.oz
d) in ml
5. The scales are now ready for use. Place
the object to be weighed in the centre
of the platform. When the digits on the
display remain fixed, you can make
the reading. The display reading is as
follows:
6. Make sure that the scales show "zero"
weight before starting to weigh. If not,
press the tare button to reset
7. If the scales are not used, they will
automatically switch off after 1 minute.
You can also switch them off manually
by pressing the
seconds.
7. WARNING: DO NOT OVERLOAD
THE SCALES
If the load capacity is exceed, the scales
may be damaged and the following warning
will appear on the display:
.
button for 2
8
8. BATTERY LOW INDICATOR
When the battery needs replacing, the
following message will appear on the
display:
When this happens, follow the adjustment
instructions.
Remember that batteries are
not household waste. Spent
batteries must be disposed
of in the special containers
provided.
9. USING THE TARE BUTTON (3)
1. Adjust the scales as described above.
2. Place a container on the weighing
platform and gently press and release
the button. After a few
seconds the display will show zero.
IMPORTANT: If the weight of the
container is over 600 g, the word TARE
will appear on the display.
3. You can now place any additional
articles to be weighed in the container,
repeating these last two steps if you
wish. The net weight of the additional
article will appear on the display:
4. If you remove an article from the
container, a negative value (-) will
appear. This represents the weight of
the article you have removed.
Press the
time you remove an article, to set the
reading to 0 again:
button again each