Setting The Clock - Geneva XS Manual Del Usuario

Ocultar thumbs Ver también para XS:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 15
uSINg thE MODEL XS
FM radio
1. T ouch until the display shows an FM
frequency, for example "103.2".
2. Select an FM station with and :
• Use a single touch: change frequency by 0.1 MHz.
• H old down for a short time: automatically search
for another station.
bluetooth
Mobile phones and computers with Bluetooth can
connect to the Model XS and play music. The mobile
phone or computer must support Bluetooth A2DP.
Initial Setup ("pairing") With iPhone
1. T ouch the key until the display shows "Blue".
Wait for 20 seconds until the display shows a
blinking "P".
2. S elect "settings" on your iPhone
Bluetooth". Turn on Bluetooth. New Bluetooth devices
are discovered automatically. After a few seconds
"Geneva XS Sound System (Not Paired)" will appear.
3. S elect "Geneva XS Sound System". The phone is
now connecting ("pairing") to the Model XS.
4. If the phone asks for a PIN: enter "0000" (four zeros).
5. N ow you can play music on an iPhone
"iPod" and listen to it on the Model XS.
Setting on iPhone
Playing music with App "iPod"
®
Playing Music
Most phones connect automatically to the Model XS
after the initial setup ("pairing").
1. T ouch the key on your Model XS until the display
shows "Blue". When Model XS connects, the display
shows "C" for a few seconds.
2. P lay music on the mobile phone, music will start
playing on Model XS automatically after a few seconds.
Pairing guides for other devices and mobile phones
Go to www.genevalab.com and select "Support."
Status information on the display
S: Searching for previously paired devices.
c: Connection successful.
P: P airing. If Model XS did not make a successful
Line-In
1. C onnect one end of the supplied Line-In cable to
2. C onnect the other end of the cable to the Line-In
3. Touch until the display shows"Line".
®
. Select "General /
®
alarm
Setting the alarm
1. T urn on Model XS, then touch : a blinking "A"
2. Set the desired alarm time using and .
App
3. T ouch again to save the alarm time. "A"
®
4. Touch
turning the alarm On and Off
Turn off Model XS, then touch any key on the touch
panel to toggle the alarm. "A" on the display indi-
cates the alarm is on.
Muting the alarm
Touch any key on the touch panel to mute the alarm.
The alarm will automatically turn off after 20 minutes
if no key on the touch panel is touched.
Selecting the alarm Sound
There are two alarm sounds: FM radio and a beeping
sound. If you set the alarm and the current mode is
FM, the FM radio will play when the alarm goes off.
Otherwise the beeping sound is used.

Setting the clock

1. T urn on Model XS, then touch . The letter "C"
2. Use and to set the current time.
3. Touch to complete the procedure.
aM/PM Display: uS version Only
The dot to the right of the minute digits indicates
AM or PM: • Off: AM • On: PM
3
connection within 20 seconds, Model XS will go
into the pairing mode for 2 minutes.
the audio device (headphone or Line-Out plug).
plug on the back of Model XS.
appears on the display.
indicates alarm is now on.
to turn Model XS off.
starts blinking on the display.
English

Publicidad

Tabla de contenido
loading

Tabla de contenido