MAC Audio PrivatEar Instrucciones De Uso página 18

BUTTON
· Turn on: Press and hold the
speaker. The power up tone sounds and the LED
indicator starts blinking.
After a few seconds, the speaker goes to
Bluetooth pairing mode to set up with your
smartphone.
· A short press selects the audio source (Bluetooth,
SD card).
PAIR AND CONNECT
Enable Bluetooth on your smartphone or other
device.
Make sure the LED indicator is blinking. (If it isn't,
switch the speaker off and on again.)
Choose PrivatEar from the pairing options on your
smartphone. (If it's not in the list, choose "Scan"
from your phone's Bluetooth menu.)
The speaker gives an audio signal when it's finished
pairing and connecting to your smartphone.
Note: The process of enabling Bluetooth and connecting
varies from device to device. See your device's owner's
manual for more information and specific instructions.
Press and hold the
3 seconds to disable Bluetooth pairing.
button of the
button for approx.
18