Cleaning And Care; Cleaning The Housing - Soehnle AIRFRESH CLEAN CONNECT 500 Instrucciones De Manejo

Clean Connect 500 display. Press again to
turn off Bluetooth®.
If the Airfresh Clean Connect 500 is connected to a mo-
bile device, it can be controlled via the control console
of the housing as well as via the Soehnle Connect app.
UV-C lamp and night-time mode
Press the button (H) once to switch on
the UV-C lamp inside the Airfresh Clean
Connect 500 (UV-C indicator is on). Press
again to activate the night-time mode
without turning off the UV-C lamp (UV-C
indicator light is on, NIGHT indicator light
flashing). Press the (H) button again to
turn off the UV-C lamp (UV-C indicator
light is off, NIGHT indicator light flashes),
or turn off both (UV-C indicator light is off,
NIGHT indicator light is off ).
Night mode
In the night-time mode, you can run the
Airfresh Clean Connect 500 without be-
ing disturbed by additional light sources.
Once you activate the night-time mode,
all indicator lights on the device will soon
be turned off without the device switch-
ing off. All previous settings for operating
time and fan speed will remain un-
changed. Activation of the night-time
mode is indicated by flashing of the indi-
cator light before the illumination switch-
es off completely.
The unit can run either in night-time mode or in au-
tomatic mode. These two modes cannot be activated
at the same time.

9. Cleaning and care

Cleaning the combination filter
Regular cleaning of the combination filter (1x
month) ensures faultless operation of the Air-
fresh Clean Connect 500 and the greatest possi-
ble room air quality.
Proceed as follows:
1. Switch the device off prior to cleaning and
disconnect the power plug.
2. Turn the device upside down and place it on
a solid surface (2.1).
3. Open the screw cap on the bottom of the
device (2.2).
4. Remove the housing base by lifting it up
(2.3).
5. Remove the combination filter (2.4) and
clean it. Replace the filter and ensure that it is
inserted correctly.
The pre-filter is attached to the filter with a hook and loop
fastener. Clean the pre-filter under running water. Ensure
that the pre-filter is dry before reattaching into the EPA
filter. EPA and activated carbon filter should be cleaned
only with a vacuum cleaner.
6. Close the device and fasten the screw cap.
Turn the device right side up and place it on
a solid surface.
7. Reconnect the power cord to a power outlet
and switch the device on.

Cleaning the housing

Switch the device off prior to cleaning and dis-
connect the power plug. Clean the housing of
Airfresh Clean Connect 500 with a slightly damp
cloth.
EN
13