Declaration Of Conformity; Time And Date - Alecto BDM-150 Manual De Instrucciones

This product conforms to the provisions of the EC directive
93/42/EEC (Medical Device Directive).
The declaration of conformity is
available on the website
WWW.ALECTO.INFO
INSTALATION
Batteries:
1. Remove the battery cover and insert four batteries with
correct polarity (see the symbol in the battery compartment).
2. Replace the battery cover.
Only discard of empty batteries. They should not be
disposed off in the household waste, but at appropriate
collection sites or at your dealer.
Main unit:
Connect the air connector with the air plug and securely affix
the fastening hole to the fastening protrusion.
Arm cuff:
1. Turn the palm of your hand upward. Place mark
cloth inside your arm and match the end of the
arm cuff to approximately 1-2 cm from the
flexed side of the elbow joint of
your arm (nipple level) and
wrap the arm cuff on the arm.
2. Hold the end of the arm cuff
and wrap it up by gently pulling so
that there is no gap between the arm cuff and the arm.
Because the time and date of a measurement are stored toge-
ther with the measuring-results, the actual time and date must
be set:
1. Press and hold button
year indication starts to flash, you may now release this
button.
2. Use buttons
button
3. Repeat instruction 2 for the date, hour and minute settings.

DECLARATION OF CONFORMITY

TIME AND DATE

and
, the month indication starts to flash.
until after appr. 5 seconds the
to set the correct year and press
30