I
H
F
16
Operation and use
How to operate to brew coffee
1. If the door is open, close the door first. Open the
tank cover (B) and take out the water tank (C).
Fill water tank with appropriate water and repla-
ce it till its place, and then close the water tank
cover. Alternatively, use the other container to
directly fill appropriate water into the water tank
without taking out the water tank, then go to step
3.
Note:
Always observe water tank (C) to make sure
adequate water within it during the brewing pro-
cess.
2. Press down the door knob (O), the alum door (E)
will open automatically and some part of anti drip
K
tray (F) will eject.
3. Unfold the handle of the funnel bracket from the
recess, then detach the funnel bracket (I) clock-
wise and rotate the steam duct (D) to the right
door.
J
4. Plug power cord to the power socket and press
down power button (P), then the power light (S)
and the coffee light (Q) will come on simulta-
neously. Subsequently press down brewing but-
I
ton (R) to pump water from water tank (C) to boi-
ler. Once water is noticed to run out of the single-
direction valve (which implies that boiler has
been full of water), press down brewing button
H
(R) once again.
5. Prepare the coffee powder and fit the appropria-
te amount into the filter (K).
Note:
Pay attention not to have this filter too full.
Tamp the coffee powder with presser (M). The
coffee light (Q) will go out once temp reaches
certain value, now please insert the valve cover
I
(J) and filter (K) into the funnel bracket (I) in the
H
order indicated.
And then fit the funnel bracket back to the unit
and rotate counter-clockwise for steady fitting (as
drawing shown)
ATTENTION:
Once happen unfavorable fitting, repeat the fit-