Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Perform a cut
Loosen the clamping lever(4) and swing the saw
arm to the desired angle. Tighten the clamping
lever again to fasten the saw arm in the chosen
position.
Swing the saw arm into the upmost position.
Place the workpiece according to the desired cutting
line and fix it with the vice
Loosen the saw blade guide (7) and move it
approx. 2cm near the workpiece.
Für cutting workpieces of same length, adjust the
workpiece stop (5) accordingly.
Now adjust the speed governor (3) to the desired
feed rate.
Press the green button (2).
Take the feeding handle (1) and press the start
button on it. Wait until the blade reaches its full
speed.
Perform the cut. You should adjust the feed
dependent from the material.
Stainless steel, bronze: very slow feed
Steel, brass: slow feed
Aluminium: moderate feed
Wait until band stop and saw arm
in upper position before removing
the cut workpiece and/or placing
a new workpiece into the vice.
I N F O R M A T I O N
If you do not use anymore the
band saw the same day, loosen the
saw blade with the knob(9) a bit.
HOLZMANN Maschinen Austria ξ www.holzmann-maschinen.at
W A R N I N G
MAINTENANCE
Don't clean or do maintenance on
the machine while connected to
the power supply:
Damages to machine and injuries
might occur due to unintended
switching on of the machine!
The machine requires barely no maintenance.
However, if malfunctions and defects occur, let
them be serviced by trained persons only.
Clean your machine regularly after every usage–
it prolongs the machines lifespan and is a
prerequisite for a safe working environment .
Before first operation as well as later on every
100 operation hours you should lubricate al
connecting part (if required, remove beforehand
with a brush all swarfs and dust).
Check regularly the condition of the security
stickers. Replace them if required..
Check regularly the condition of the guiding rollers
of the saw blade. The good condition and perfect
adjusting of the guiding rollers is essential for a
smooth band saw transport and a clean cut.
Store the machine in a closed, dry location. Do
not expose it to high levels of humidity.
Maintenance and servicing plan
Check for loose or lost
screws
Check for damages of
any machine part
Clean machine
Lubricate all moving
parts (esp. Gear box)
Adjust guiding rollers
A T T E N T I O N
Prior to operation
Prior to operation
After operation
After first 10
operating hours,
later every 3
months
Every month
page 12
Publicidad
Tabla de contenido
