Stake Mounting Method; Connecting A Weather Sensor - Hunter SVC Instrucciones De Instalación Y Manual Del Usuario

Stake Mounting Method (Figure 3)
The universal mounting adapter can also be used to stake
mount the SVC.
1. Cut a section of ½" diameter plastic pipe.
2. Drive the pipe into the ground inside the valve box to
the desired height of the controller.
3. Slip the mounting adapter on top of the pipe.
4. Attached the SVC to the mounting clip and slide onto
the adapter.
Figure 3

CONNECTING A WEATHER SENSOR

A Hunter Mini-Clik
SVC. The purpose of this sensor is to stop watering when
weather conditions dictate.
1. Cut the yellow wire loop attached to the SVC at approxi-
mately the middle of the loop.
2. Remove approximately ½" (13mm) of insulation from
each wire. Attach one yellow wire to each of the wires
Mounting
of the weather sensor. You can mount the rain sensor
Adapter
up to 100 feet from the SVC controller (18 GA minimum
wire size).
Mounting Clip
3. Secure wire connec-
Plastic Pipe
tions with waterproof
connectors.
rain sensor can be connected to the
®
NOTE: When the Rain Sensor is interrupt-
ing the watering, the display will show the
System Off icon , "OFF" and
the display.
Hunter Model Mini-Clik
ENG
on
®
7