All Models; Before You Start - Danfoss RT51 Instrucciones Del Usuario

All models

GB

Before you start

To reset the unit, open the fl ap on the
front of the programmer. Remove the
batteries for 2 minutes, then replace.
The display will automatically default to
DAY mode (d shown top left of display)
and show actual temperature in the large
characters and required temperature in
the smaller characters.
Setting the DAY & NIGHT temperatures
DAY temperature
Use the
required DAY temperature is shown.
NIGHT (set-back) temperature
Press and
select NIGHT mode (n shown top left of
display).
Use the
required NIGHT (set-back) temperature
is shown (between 5-30°C or Off ).
10
and buttons until the
buttons together once to
and buttons until the
C
20.0
22
C
20.0
22