Roadstar CD-815UMP Manual De Instrucciones página 5

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 27
Front panel
ATTACHING THE FRONT P ANEL
Make sure the front panel is the right way up when attaching it to the unit as it cannot be
attached upside down. Bring side B of panel to side A of main unit.
Insert the panel in and push until it clicks.
Panel is attached.
Rear of the front panel
Main unit
Notes:
Do not press the front panel hard against the unit when attaching it. It can be easily
attached by pressing it lightly against the unit.
When you carry the front panel with you, put it in the supplied front panel case.
Do not press hard or give excessive pressure to the display window of the front panel
when attaching it to the unit.
5
English
Panel case
Front panel
Front panel
6
English
BUILT- IN ISO CONNECTOR
RCA Jack Line Out (Rear) -
Gray : Red (right)
: White (left)
CONNECTOR A
1.
2.
3.
4.
MEMORY +12V
5.
AUTO ANTENNA OUTPUT
6.
7.
+12V (TO IGNITION KEY)
8.
GROUND
Note: 12 V wire (connector A no. 7) must be connected by car ignition key in order to avoid
that car battery becomes weak when the car will be not used for long period.
CONNECTOR B
1.
REAR RIGHT SPEAKER (+)
2.
REAR RIGHT SPEAKER (-)
3.
FRONT RIGHT SPEAKER (+)
4.
FRONT RIGHT SPEAKER (-)
5.
FRONT LEFT SPEAKER (+)
6.
FRONT LEFT SPEAKER (-)
7.
REAR LEFT SPEAKER (+)
8.
REAR LEFT SPEAKER (-)
Maintenance
FUSE REPLACEMENT
If the fuse blows, check the power connecton and replace the fuse. If the fuse blows again
after the replacement, there may be an internal malfunction. In this case, consult your
nearest repairing centre.

Publicidad

Tabla de contenido
loading

Tabla de contenido