Care And Cleaning; Lcd Prikaz English - hafele WES 30 Instrucciones De Uso

ENGLISH
The scales can be used in a
drawer or on top of any lat
surface. If they are used in a
drawer, they can be slid to the
back or front of the drawer by
slightly lifting up the front edge.
Fold out the front and back
covers of this booklet to view the
diagrams showing the appliance
and how to use it. Please carefully
read through these instructions
before using the appliance.
Keep these instructions in a safe
place and include them with the
appliance if you dispose of it.
Important instructions:
• Do not immerse the
appliance in water or
expose it to rain or other
liquids.
• Use the appliance only at
home for non-commercial
purposes.
• No liability is accepted for
any damage resulting from
improper use, exceeding
the maximum weight
capacity (2000 g / 4 lb 6 oz)
or incorrect operation.
INITIAL USE / REPLACING
THE BATTERY
If the battery is low, the "Lo"
indicator will be shown on the
display. The battery must be
replaced.
Pull the extension (d) all the
way out.
Open the battery compartment
(e) by pressing the catch toward
the battery compartment and lifting
off the cover.
Place 4 type AA 1.5 -V
(mignon) batteries in the battery
compartment as indicated by the
markings, being careful to observe
the correct polarity. Close the
battery compartment.
Set the desired units (grams
or pounds) using the selector
switch (f).
Adjust the extension (d) to
match the width of the drawer.
Place the built-in scales in the
drawer.
WEIGHING
Switch on the scales by briely
pressing the pushbutton (c).
Caution: do not place anything to
be weighed on the scales during
the initialisation stage (display
"88888").
If you do not want the weight of the
weighing container to be included
in the displayed weight, place
the container on the weighing
surface (a) and again press the
pushbutton. The display will be
reset to '0'. Now you can measure
the weight of the material to be
weighed.
Measure the weight of the material
on the scales. If the display shows
"-----", the measuring range of
the scales has been exceeded. In
this case, divided the material to
be weighed into several portions
and weight them in turn.
Additive weighing (for example,
when mixing several ingredients):
after weighing each ingredient,
again press the pushbutton. The
display will be reset to '0'. Now you
can weight the next ingredient.
NOTE:
If the weighing container is
removed after additive weighing,
the scales will display a negative
weight. You can use this to verify
the total weight of all of the
ingredients.
To switch off the scales, press the
pushbutton switch. The display will
be reset to '0'. If the pushbutton
is pressed again, the scales will
be switched off. If the scales
remain unused for longer than
2–3 minutes, they will switch off
automatically.

CARE AND CLEANING

Wipe off the surface of the built-in
scales using a lightly moistened
cloth, without any cleaning agents.
Never immerse in water!
DISPOSAL
Dispose of the appliance in an
ecologically responsible manner
(such as at a recycling centre).
All types of batteries require
special disposal and must never
be discarded with household
rubbish.
WARRANTY
This ritter appliance comes with a
two-year manufacturer's warranty,
starting with the date of purchase
and in accordance with the EU
warranty directives. In the event of
a warranty claim or for servicing,
the appliance must always be
sent to the appropriate national
customer service centre.
Number plate
(on the bottom of the appliance)
5