Hybrid Cleaning - Samsung NV51K6650S Serie Manual De Uso

After a self-cleaning cycle
• You may notice some white ash in the oven. Wipe it up with a damp cloth
after the oven cools. (If white spots remain, remove them with a soap-filled
steel wool pad and rinse thoroughly with a vinegar and water mixture.)
• If the oven is not clean after one cycle, repeat the cycle.
• You cannot set the oven for cooking until the oven is cool enough for the door
to unlock.

Hybrid Cleaning

The Hybrid cleaning function saves time and energy by removing leftover grease
and residue that you can then wipe away with a damp cloth.
CAUTION
• Do not line the oven walls, racks, bottom, or any other part of the oven with
aluminum foil. Doing so will result in poor heat distribution, poor baking
results, and cause permanent damage to the oven interior. Aluminum foil will
melt and adhere to the interior surface of the oven.
• The oven door locks during Hybrid cleaning. Do not force the oven door open.
This can damage the automatic door locking system. Use care when opening
the oven door after a Hybrid Cleaning cycle is complete. Stand to the side of
the oven when opening the door to allow hot air or steam to escape.
NV51K6650S_DG68-00855A-00_EN+MES+CFR.indb 37
Before a Hybrid cleaning cycle
•
•
•
Fig. 1
•
Don't hand
clean the
oven door
gasket.
You may
•
hand clean
the door.
Fig. 2
•
NOTE
Remove oven racks and accessories before starting the Hybrid clean mode.
Remove the wire rack, broil pan, broil
pan insert, all cookware, and any
aluminum foil from the oven.
Wipe up debris from the oven bottom.
(Fig. 1)
The silver-colored oven racks can be
Hybrid Cleaned, but they will darken,
lose their luster, and become harder to
slide.
Residue on the front frame of the oven
and outside the gasket on the door
will need to be cleaned by hand. Clean
these areas with hot water, soap-filled
steel-wool pads, or cleansers such as
Soft Scrub. Rinse well with clean water
and dry.
Do not clean the gasket. The fiberglass
material of the oven door gasket cannot
withstand abrasion. It is essential for
the gasket to remain intact. If you
notice it becoming worn or frayed, have
it replaced. (Fig. 2)
Make sure the oven light cover is in
place and the oven light is off.
English 37
2016-08-17 11:22:30