General Maintenance - Ubermann UJS04BRA Manual Del Operador

OPERATION
• Mark the line of cut clearly on the workpiece.
• Set the cutting angle at 0° and the orbital adjustment knob
to 0.
• Drill a pilot hole though any point on the line of cut.
• Using high speed, start the saw and slowly lower the blade
through the pilot hole into the workpiece until the blade cuts
through the wood.
MAINTENANCE
WARNING:
When servicing, use only identical replacement parts. Use of any
other part could create a hazard or cause product damage.
WARNING:
Always wear eye protection with side shields marked to comply
with ANSI Z87.1 or equivalent standard. Failure to do so could
result in objects being thrown into your eyes and other possible
serious injuries.
WARNING:
To avoid serious personal injury, always remove the battery pack
from the tool when cleaning, performing any maintenance, or
when storing the tool.
• Do not move the base forward until the blade cuts entirely
through the workpiece and the base is in complete contact
with the workpiece.
• Move the saw forward to complete the opening.
• Use only blades with seven teeth per inch for this type of cut.

General Maintenance

Avoid using solvents when cleaning plastic parts. Most plastics
are susceptible to damage from various types of commercial
solvents and can be damaged by their use. Use clean cloths to
remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-based
products, penetrating oils, etc., come in contact with plastic
parts. Chemicals can damage, weaken or destroy plastic which
could result in serious personal injury.
11 — English