Truma CP F Instrucciones De Uso página 5

Installation instructions
Safety instructions
Only qualified technicians may assemble and connect electri-
cal devices!
Ensure that the power supply has been disconnected! Discon-
nect the mains plug!
Only use the supplied parts and the specified cable cross-sec-
tions and fuses to connect the device!
Only use suitable and fully functional tools.
Only wire the device as specified in the supplied wiring
diagram!
Installation
Installation in vehicles must accord with the technical and
administrative provisions of the individual country of use
(e.g. EN 1648). The national legislation and regulations must
be observed.
In other countries always observe the respectively valid
regulations.
Remove the equipment pack (accessories) and check it is
complete:
1 Instructions for installation and use
6 Flat pin bushing 6.3 mm
4 Mounting screws
Install the panel in a place that is protected from damp and wet.
Prepare an installation opening for the device.
R 4
All dimensions in mm.
80
Dia. 1.5
Wiring diagram
1
12 V / 12 A
IV
12 V / 10 A
I
12 V / 7 A
II
12 V / 7 A
III
From BCO 70 to the circuit breaker IV
From the circuit breaker IV – to the refrigerator
+12 V consumers via the circuit breaker I, II or III
Attach the fuse close to the positive terminal of the supply
battery (battery II)
Connection
Before connecting or disconnecting the cables, the
supply lines to the battery and mains supply must be
disconnected! Only use the specified cable cross-sections and
fuses of the correct strength!
Cable lengths and cross-sections
Cable length Current
up to 1.5 m
up to 3 m
15 (30) A
up to 6 m
over 6 m
– Connect the device according to the wiring diagram.
– Check all connections are tight.
– Attach the device with the supplied screws.
CP F CP F
I
II II
III III
Mainswitch 12 V Mainswitch 12 V
4
3
12 V
Cable cross-section
1.5 (4) mm²
2.5 (4) mm²
4.0 (6) mm²
6.0 (10) mm²
5