Troubleshooting - BLACK&DECKER BM903650 Serie Manual Del Operador

PROBLEM
Engine will not start.
Engine lacks power.
AC receptacle does not work.
Generator makes a "spark knock" or
"pinging" noise.
If problem persists after trying the above solutions, contact your nearest authorized service center for assistance.
The following symptoms may indicate problems that will affect the emissions level of the unit:
 Hard starting or stalling after starting
 Rough idle
 Misfiring or backfiring under load
 Afterburning (backfiring)
 Black exhaust smoke or high fuel consumption
If you encounter any of these symptoms, have the unit inspected and repaired by the nearest authorized service
center.

TROUBLESHOOTING

POSSIBLE CAUSE
Engine switch is OFF.
No fuel.
Lubricant level is low.
Fuel valve is OFF.
Spark plug faulty, fouled, or improperly
gapped.
Choke lever is in RUN position.
Engine stored without treating or
draining gasoline, or refueled with bad
gasoline.
Fuel element clogged.
Engine stored without treating or
draining gasoline, or refueled with bad
gasoline.
Circuit breaker is OFF.
Item plugged in is defective.
An occasional light "knocking" or "ping-
ing" under heavy load is not a cause
for concern. However, if the knocking
or pinging occurs under normal load
at a steady engine speed, the problem
may be with the brand of gasoline be-
ing used.
Page 19 — English
SOLUTION
Turn engine switch to ON.
Fill fuel tank.
Check engine lubricant level and fill, if
necessary.
Turn fuel valve ON.
Replace spark plug.
Move choke lever to START position.
Drain fuel and carburetor. Refuel with
fresh gasoline.
Check air filter element. Clean or replace
as needed.
Drain fuel and carburetor. Refuel with
fresh gasoline. If problem continues,
contact your nearest authorized service
center.
Turn ON the AC circuit breaker.
Try a different item.
Switch to a different brand of gasoline,
making sure that the octane rating
is 86 or higher. If problem continues,
contact your nearest authorized service
center.