Metabo PE 12-175 Instrucciones De Manejo página 9

PE 12-175_ v5 Über.ENG
9.1 Installing hand protection
(for work with the support plate and
sanding sheet, or lambskin polishing disc
with cord drive)
5
Fit the hand protection (5) via the threaded
element on the additional handle (6). Align hand
protection and install with additional handle.
9.2 Installing support plate and
sanding sheet
Only use the adjusting nut supplied with
the support plate.
Place the support plate on the spindle as shown
in the illustration. Screw on sanding sheet with
adjusting nut supplied with support plate. Locking
the spindle. Tighten sanding sheet with support
plate manually in a clockwise direction.
Release by hand or with a two-hole spanner if
necessary.
18.12.2007
6
11:25 Uhr Seite 9
10 Maintenance
Disconnect the mains plug before starting any
maintenance work.
Motor cleaning: blow compressed air through the
rear ventilation slots of the machine regularly,
frequently and thoroughly. Here, the machine
must be held firmly.
The Autostop carbon brushes must be replaced in
a specialist workshop. Always have checks and
maintenance work carried out by Metabo
Customer Service.
11 Troubleshooting
Restart protection
If the mains plug is inserted with the machine
switched on, or if the current supply is restored
following an interruption, the machine does not
start up.
The red electronic signal indicator (6) starts
flashing.
Switch the machine off and then back on again.
The electronic signal indicator (6) lights up
and on-load speed is reduced.
Winding temperature too high. Run the machine
in idling until the electronics signal indicator
switches off.
12 Accessories
Use only genuine Metabo accessories.
If you need any accessories, check with your
dealer.
For the dealer to select the correct accessory, he
needs to know the exact model designation of
your power tool.
See page 4:
a Foam polishing disc, coarse with velcro-type
fastening
b Foam polishing disc, fine with velcro-type
fastening
c Foam polishing disc, profiled with velcro-type
fastening
d Felt polishing disc, hard with velcro-type
fastening
e Felt polishing disc, soft with velcro-type
fastening
f Lambskin polishing disc with velcro-type
fastening
g Lambskin polishing disc with cord drive
h Sanding fleece with velcro-type fastening
i Adhesive intermediate disc with velcro-type
fastening
j Buffing disc 200 x 20 mm
ENGLISH
9