Midland C1332 Manual De Usuario página 9

Setup
At first, the camera has to be paired with the monitor; follow these steps:
6. Select a free channel on the monitor (no camera paired)
7. Enter the menu of the monitor
8. Select the PAIRING option
9. Turn on the camera before the timer expires
10. You can also pair the new camera on an already assigned channel, but in
this case the previous pairing will automatically be deleted.
Auto channel switch
(if you have more cameras installed)
The monitor cable has 4 coloured "TRIG" wires (Green - 1, White - 2, Yellow -
3, Blue - 4), and each one corresponds to one of the four channels.
Connecting the corresponding TRIG wire to the positive pole (+) the monitor
will automatically switch to that channel. When the wire is disconnected, the
monitor will return to the previous channel.
From SYSTEM  DELAY TIME you can set the time to wait before retur-
ning to the previous channel when the TRIG cable is disconnected.
Example of typical 2 channel setup:
1. Front camera always on and recording everything that happens on the
road (set on channel 1)
2. Rear camera to help you while reversing (set on channel 2)
3. Connecting TRIG - 2 (white wire) to the reverse, the monitor will automa-
tically switch to view rear camera when reverse gear is inserted.
4. When reverse gear is switched off, monitor will return to show the front
camera (this function is active on all 4 channels).
Important: the unit records only what you see on the screen. When the TRIG is
activated, the unit records the video from the triggered channel.
If you want to have the recording always enabled on a defined channel, you
don't have to use the TRIG function, but to activate the SPLIT view (from
MODE  SPLIT).
7