Fcc Notice - Furman F1500-UPS Manual Del Propietário

OUTLET STATUS CHANGE CONDITION
Outlet Bank 1 changes state
Outlet Bank 2 changes state
Outlet Bank 3 changes state
Outlet Bank 4 changes state
status = {ON, OFF}
POWER BUTTON
STATUS CHANGE CONDITION
Power Button changes ON/OFF status
status = {ON, OFF}
POWER FAULT
STATUS CHANGE CONDITION
Overvoltage State
Undervoltage State
Lost Power State
Test Mode
Recovery Mode
Normal Operation Mode
Low Battery
AVR Stage
Remaining Backup Time
Battery State
Power Control Software
Complete Instructions are available by clicking on Help on the Power Control Software welcome screen.

FCC NOTICE

This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment and receiver.
(3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
(4) Consult the dealer or an experienced radio/TV technician for help. Any special accessories needed for compliance must be
specified in the instruction.
CAUTION: A shielded-type power cord is required in order to meet FCC emission limits and also to prevent interference to the
nearby radio and television reception. It is essential that only the supplied power cord be used. Use only shielded cables to con-
nect I/O devices to this equipment.
CAUTION: Any changes or modifications not expressly approved by the guarantee of this device could void the user's authority to
operate the equipment.
RESPONSE
$BANK1 = status<CR>
$BANK2 = status<CR>
$BANK3 = status<CR>
$BANK4 = status<CR>
RESPONSE
$BUTTON = status<CR>
RESPONSE
$PWR = OVERVOLTAGE<CR>
$PWR = UNDERVOLTAGE<CR>
$PWR = LOST POWER<CR>
$PWR = TEST<CR>
$PWR = RECOVERY<CR>
$PWR = NORMAL<CR>
$LOWBAT<CR>
$AVRSTATE = state<CR>
state = {BOOST, BUCK}
$TIME = xxx<CR>
xxx = backup time
$BATTSTATE = xxx<CR>
xxx = {CHARGE, DISCHARGE, FULL}
17