Viking smrt-air-2 Manual Del Usuario página 2

To add a PIN enter a 4 to 6 digit PIN and press
completed. The escutcheon signals with the blue led when the digit has been entered correctly.
3. When all user and shadow cards are added, approach the programming card and the process ends. If this
is not done, the device waits a few seconds finishing the process itself.
5. ADD Users that CAN change to Passage Mode
Important: Knob Cylinders cannot be left in Passage Mode
The only difference with the process just described above is that the programming card has to be approached twice
consequently to the device to chance into programming mode. Consider that when the card is approached for the
second time to the device, the lights blink faster. The rest of the steps are the same.
6. Start/Stop Passage Mode
Instructions v5.0 – P-E04000_A_N. Shadow Progamming Cards
: the green light blinks advising that the process has been
Standalone System