Bestron COPPER COLLECTION E AES1000CO Manual Del Usuario página 27

OPERATION - General
The expresso machine is only intended for
household use.
1. Cup heater
2. Power indication light
3. Ready-for-use indication light
4. Selection button
5. Filter
6. Filter holder
7. Locking clip
8. Handle filter holder
9. Drip pan
10. Drip tray
11. Lid water reservoir
12. Handle water reservoir
13. Water reservoir
14. Steam pipe
15. Protective pipe
16. On/off switch
17. Measuring spoon
OPERATION - Before first use
1. Remove the packaging.
2. Clean the machine. See 'Cleaning and maintenance'.
ATTENTION:
• If the machine is new, or has not been used in a long time, use it two to three times with only water,
not coffee. Follow the normal instructions below. Throw away the water afterwards.
OPERATION - Preheating
For making a cup of hot steaming expresso, it is best to preheat the machine (the filter holder, the filter and
the cup) so the coffee taste is not affected by the cold parts.
1. Remove the detachable water reservoir (13) and open the lid (11) to fill the water reservoir with water,
the water level must not reach above the marking "MAX". Then place the water reservoir correctly in
the machine.
2. Place the filter (5) in the filter holder (6), make sure that the notch is aligned with the groove. Then
place the filter holder in the machine from the position "
in the " " position.
3. Place one or two expresso cups on the drip pan (9).
4. Connect the machine to a socket. Make sure that the selection button (4) in the middle is in the "
position.
5. Press the ON/OFF switch (16), the power indication light (2) lights up red.
6. If the ready-for-use (3) keeps lighting up white, turn the selection button to the "
water will run through the filter holder. Return the selection button to the "
expresso cup is filled with hot water. Preheating is finished.
", turn the filter holder counter-clockwise
27
"
" position, hot
" position when the
EN