Configuration Options - PeakTech 5500 Manual De Usuario

Turn Alarm indicator on or off
7. Press [<] or [>] to turn the LEDs on or off.
8. Press [Hold] to confirm.
Switch calibration mode (CAL) on or off
9. Press [<] or [>] to turn the CAL mode on or off
10. Press [Hold] to confirm.
Factory Reset (RST)
11. Press [<] or [>] to select Reset on or off.
12. Press [Hold] to save and exit.
Switch the background lighting (BL) on or off
13. Press [<] or [>] to turn the backlight on or off.
14. Press [Hold] to save and exit.
(Press the [Power] key in the configuration mode to leave the configuration mode at any time)

7. Configuration Options

Configuration
Set the temperature
Setting (LED)
Set the sound ALA (Alarm)
Perform calibration (CAL)
Execute Reset Reset (RST)
Set the automatic shutdown (OFF) on：automatic shutdown is turned on
Set the backlight (BL)
8. Advanced alarm settings
Switch TMP Alarm (High) on
1. Turn on the unit and press the [<] key for about 3 seconds until the LEDs turn red.
2. Press the [<] or [>] button to set the alarm value
3. Press [HOLD] to save the setting or [Power] to return to normal measurement mode without saving.
Switch TMP Alarm (Low) on
1. Turn on the unit and press the [>] button for about 3 seconds until the LEDs turn green.
2. Press the [<] or [>] button to set the alarm value
3. Press [HOLD] to save the setting or [Power] to return to normal measurement mode without saving.
configuration options
in ° C or ° F
on：LED alarm is activate
off：LED alarm is released
on：sound alarm is activated
off：The sound alarm is released
on：Perform calibration
off：No calibration is performed
on：Resets to factory settings
off：will not be reset
off：automatic shutdown off
on：backlight turned on
off：backlight off
12