EHEIM powerLED+ fresh daylight Manual De Instrucciones página 13

English
‧ The distance from the underside of
the light to the highest water mark
must be a minimum of 15 mm.
4. Commissioning
Installation (⌦A)
1. The LED lights can be adjusted to the width
Electrical connection
1. Connect the plug of the LED lights to the
The matching EHEIM power supply unit can be
found on the packaging of your LED light.
5. Operation
Service life
In order to avoid excessive algae formation,
you should not put the LED lights in continuous
operation.
Optional accessories
Use with Y distributor
The Y distributor allows you to operate two LED lights from
one power supply unit.
Ensure that the maximum power output of the
power supply unit is not exceeded (see Techni-
cal Data, page 107)
Use with T5/T8 adapter
With the T5/T8 adapter, you can replace traditional fluores-
cent bulbs with an LED light. To do so, proceed as follows:
1. Push both adapter parts b/c until they click onto the
extendable bracket a (⌦C).
Attention! Electrocution!
▶ Before all assembly work, remove the mains
▶ Keep the lighting unit or cover disconnected
▶ Secure the mains plug of the lighting unit or
2. Loosen the end cap e and remove the fluorescent
bulb.
of your aquarium with the freely adjustable
extendable bracket a. Pull the extendable
bracket out of the light housing until it
reaches the desired length.
socket of the matching EHEIM power supply
unit.
plug of the lighting unit and or cover.
from the mains!
cover against any unintentional connection
to the socket
13