Technical Features - Hayward Powerline PL Manual Del Usuario

The spotlight must shine in the opposite direction to the house or terrace to avoid the lighting being too harsh.
The spotlight must be positioned 60cm maximum under the rim of the pool, measured from the axis of the bulb. The spotlight recess is supplied with
two 3/4" outputs. The rear output is generally used for brick-built pools and the vertical output for panel-built pools.
Brick and liner structure
• Install the construction protection on the front of the recess.
• Seal the spotlight recess in the brickwork. Finish the plaster flush with the front surface, making sure the recess is orientated upwards. Block the
unused outlet using the plug.
• Install the seal on the front of the spotlight recess.
• Install the seal on the spotlight recess flange.
• Attach the sealing flange after the liner has been installed.
• Cut the liner
Panel and liner structure
• Use the template to drill the panel
• Install the spotlight recess from inside the pool. Screw it onto the panel after installing the foam, placing the spotlight unit fastening grooves in a
horizontal position.
• Seal the liner, the sheath and the cable and install the spotlight unit in the same way as the liner spotlight.
Brick structure without liner
• Seal the spotlight recess into the brickwork, with the front part set back to allow the finishing plaster or tiling to be installed.
• Seal the liner, the sheath and the cable and install the spotlight unit in the same way as the liner spotlight.
Installing the spotlight
• Pass the spotlight unit cable through the cable gland. Ensure the cable gland fitting is correctly positioned.
• Push the spotlight unit cable through the sheath to the terminal box.
• Seal the cable with the cable gland. Ensure the cable gland fitting is in the correct position. (the 30° end is positioned in the bottom of the cable
gland body).
• Hold the spotlight in front of the recess, winding the extra cable into it.
• Fit the spotlight into the recess, placing the prongs into the grooves.

Technical features:

Type of LED bulb
Supply voltage
Consumed power (RGB LEDs)
Consumed power (white LEDs)
Maximum operating temperature
Number of RGB LEDs
Number of white LEDs
RGB colour control
IP
Transformer power
The transformer to be used must have a secondary voltage of 12V (12.5V depending on the model). The power must be suitable for the power of the
spotlight(s) to be connected.
In all cases, the total power of the spotlights must be less than or equal to the power of the transformer.
Each spotlight requires individual protection. Protection must be provided for the transformer secondary winding using 5A or 6A fuses or circuit
breakers (see wiring diagram below).
USE ONLY hAYWARD GENUINE REPLACEMENT PARTS
Page 3 of 4
INSTALLATION
PAR-56
12 V 50Hz / 60Hz
18W
18W
35°C
270
270
By remote (433 MHz) or On/Off
IP68 1,0m
PL LED Light Rev. B