Publicidad
Idiomas disponibles
Idiomas disponibles
A: Canopy
B: Frontbar
C: Five point harness system
D: Basket
E: Front wheel
1.-2. Open:
Unhook the folding locker, uplift the handle bar
until the tube click into position.
3. Attaching the front wheels:
Insert the front wheel sets into the housing until
it clicks into the knukle and make sure the wheel
attached well;rotate the locher clockwise to
make the wheel to straight,on the counterclock-
wise rotaion to make the wheel swivel.
4. Attaching the rear wheels:
Put the wheel set into the housing as shown,and
make sure they are clicked into position and at-
tached well.
5. Adjust rear wheel brakes:
Step on the rear part of the brake to stop, to re-
lease brake, step on the front part.
6. Install the bumper bar:
Click the front bar into the plastic housing and
make sure it is fixed into position.
7. Install and move the seatunit:
Place the seat unit on to the mounting points on
the both side, push down until the button located
in the holes of the seat mountings,press the but-
ton on the both side to move the seat out.
F: Rear wheel
G: Folding locker
H: Function button
I: Folding mechanism
J: Handle bar
8. Harness Release:
Press down the button on the buckle, pull it to
open.
9. Harness fastening:
Insert the two latches into the buckle on both si-
des
until they click for locking. Sliding adjusters are
fitted and should be carefully adjusted on each
side so the harness fits your child comfortably.
10. Canopy installation and use:
Canopy installation: Buckle up the canopy to the
upper seat frame.
Canopy using: Pull forward the canopy to stretch
the
canopy , and back to fold.
11. Adiust the seat and backrest position:
Press the button to adjust the seat unit within
4-position; Notice:make sure the seat unit lock in
place.
12. Folding:
Adjust front wheel to swivel,then press the 2nd
locker,and pull the folding system on the both
side, downward the stroller into lock it.
EN
Publicidad
