Assembling The Handle; Fastening The Gear Attachment On The Machine; Maintenance - Mafell A-DMV X3 Manual De Instrucciones

additional handle. It is not permitted to install
several X3 in series.
4

Assembling the handle

Screw together the parts as shown and firmly fasten
by hand (Fig. 1 and 2).
5 Fastening the gear attachment on
the machine

Push the X3 completely onto the machine until
the profiles of the components fully interlock.

Adjust the clamping force at the adjusting screw
(2):
The clamping force is correctly set if the
clamping arm (3) can only be moved down to
the limit stop by exerting force and the X3 is
firmly attached to the device (Fig. 3).

Slide the clamping arm (3) downwards up to the
limit stop with force, thus fastening the X3 on
the machine (Fig. 4).

Slide the additional handle completely on (4)
until the profiles of the components interlock.

Firmly fasten the additional handle by turning.
Check whether the handle and the X3 are firmly
attached (Fig. 5 and 6).
6

Maintenance

MAFELL machines are designed to be low in
maintenance. The ball bearings used are greased for
life. After the machine has been in operation for some
time, we recommend to take it to an authorised
MAFELL customer service shop for inspection.
-10-