Device Identification; Technical Data; Scope Of Supply; Use According To Intended Purpose - Mafell A-DMV X3 Manual De Instrucciones

2.2 Device identification

All details required for device identification are available on the rating plate attached on the side.

2.3 Technical data

Translation
2.3.1

Scope of supply

Torque attachment X3 complete with:
1 gear
1 additional handle
1 connecting piece to the gear
1 handle extension
1 torx bit 1/4''
1 operating manual

2.4 Use according to intended purpose

Torque attachment X3 is only intended to be used
with the Mafell devices A18 M bl and ASB18 M bl.
When it is to be used with these machines, the
additional handle included in the supply must be
installed and used in its full length. Machine, X3 and
additional handle are equipped with a special profile
on the clamping neck and are thus matched to each
other.
Caution
For safety reasons, the torque
attachment X3 may not be used
with other machines.
The manufacturer shall not be liable for any damage
arising from another use.
3

Safety instructions

Danger
Always observe the following safety
instructions and the safety
regulations applicable in the
respective country of use!
CE symbol to document compliance with the basic safety and health
requirements according to Appendix I of the Machinery Directive.
To reduce the risk of injury, please read the operating instructions.
-9-
1/3 slower
- Please keep all safety instructions and instructions
and only pass on the device together with these
documents.
- Before using the device, please attentively read
the enclosed safety instructions and the directions
for use in their entirety.
- Also pay attention to the operating instructions for
the drive motor.
- Use the additional handle in its complete installed
length of 630 mm. In this manner, it is matched to
the high torque.
- Additional handle and X3 must be correctly
installed.
- Losing control of the machine may lead to injuries.
- Very high back torques may occur!
- Always hold the X3 and the machine with both
hands at the handles intended for that purpose.
- Take up a secure stand and work with
concentration.
- Do not use on ladders or in raised positions.
- A damaged or fissured additional handle must be
replaced. Do not operate the device with defective