General Maintenance - Ubermann UMT04CHI Manual Del Operador

MAINTENANCE
WARNING:
When servicing use only identical replacement parts. Use of any
other parts can create a hazard or cause product damage.
WARNING:
Always wear eye protection with side shields marked to comply
with ANSI Z87.1 or equivalent standard. Failure to do so could
result in objects being thrown into your eyes and other possible
serious injuries.
WARNING:
To avoid serious personal injury, always remove the battery pack
from the tool when cleaning, performing any maintenance, or
when storing the tool.

General Maintenance

Avoid using solvents when cleaning plastic parts. Most plastics
are susceptible to damage from various types of commercial
solvents and may be damaged by their use. Use clean cloths to
remove dirt, dust, oil, grease, etc.
Replacing The Drive Gear Cover
See Figure 5, page 12.
If over time you notice the noise of the tool getting louder than
usual, check the condition of the drive gear cover. If the cap is
excessively damaged so that the metal gear is clearly visible,
remove it and replace with the spare cap included.
NOTE: To reduce the noise level of the tool, do not operate
without the drive gear cover installed.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-based
products, penetrating oils, etc., come in contact with plastic
parts. Chemicals can damage, weaken or destroy plastic which
can result in serious personal injury.
8 — English