To Adjust The Seat; To Engage And Disengage The Drive System, M125-85Fh; Operation - McCulloch M125-85F Manual De Usuario

Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
To fill fuel
WARNING: Gasoline is very flammable. Be
careful and refuel outdoors (see
on page 8 ).
WARNING: Do not use the fuel tank as a
support area.
CAUTION: Incorrect type of fuel can result in
engine damage.
The engine runs on gasoline with a minimum octane
rating of 91 RON (87 AKI), not mixed with oil. We
recommend biodegradable alkylate gasoline. Do not use
gasoline that contains more than 10% ethanol.
• Do a check of the fuel level before each use and
refuel if necessary.
• Do not fully fill the fuel tank. Keep a space of a
minimum 2.5 cm.

To adjust the seat

• Tilt the seat forward to get access to the engine
cover.
• To adjust the seat forward and rearward, loosen the
bolts below the seat. Move the seat to the correct
position and tighten the bolts.
To engage and disengage the drive
system, M125-85FH
To move the product with the engine off, the drive
system must be disengaged.
12

Operation

• Pull out the drive system lever fully to disengage the
drive on the axle.
Fuel safety
• Push the drive system lever in fully to engage the
drive on the axle.
Note: Do not use middle positions.
To lift and lower the cutting deck
A pedal on the left side of the product is used to lift and
lower the cutting deck.
1. Press down on the pedal to lift the cutting deck.
2. To lock the cutting deck in transport position, press
and hold the lock button.
3. Keep the lock button pressed and release the pedal.
The cutting deck stays in transport position.
4. To lower the cutting deck to mow position, press
down on the pedal. The lock button releases.
5. Release the pedal. The cutting deck lowers.
623 - 001 - 06.03.2018