Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3.
Using the "h+" and "m+" buttons, enter the time in which you want the command to be executed.
4.
If the command must be executed each weekday: Press the "Prog" button to store the command (The LCD displays the next
empty memory position) In this case, the programming procedure has finished.
5.
If the command must be executed one day, or in a group of days within a week: using the "DAY" button, select the
weekday in which the command must not be executed (the cursor below the weekday flashes). Confirm with the "Sel" button
(The weekday and the cursor flash)
6.
By pressing the "DAY" button again, remove the selected weekday.
7.
Repeat steps 5 and 6 for each weekday you wish to remove.
8.
Press the "Prog" button to store the command (The LCD displays the next empty memory position).
9.
The programming procedure ends after pressing the
Note: If you forget to enter certain data during the programming process, the screen flashes until it is entered correctly.
ATTENTION: Always store a switch OFF command after every switch ON command. Otherwise, the clock would trigger and never get
off.
If you accidentally remove a day in which the command should be executed, follow these steps:
1.
Using the "DAY" button, place the cursor at the desired weekday (The day and the cursor flash).
2.
Confirm the selected day by pressing the "Sel" button (the cursor flashes).
3.
By pressing the "DAY" button again, the weekday gets selected.
4.
Store the new selection by pressing the "Prog" button (The display shows the next empty memory position)
5.
To get back to the current date and time display, press
Modifying or cancelling commands
In order to modify or cancel a previously stored command, follow these steps:
Cancelling a command:
1.
Select the desired command by repeatedly pressing the "Prog" button until it is appears in the display.
2.
To cancel the command, write "--:--" into the hours and minutes fields (using the "h+" and "m+" buttons).
""
3.
Press the
button for 3 seconds. The command has now been cancelled.
Modifying a command:
1.
Select the desired command by repeatedly pressing the "Prog" button until it is appears in the display.
2.
To modify a command, overwrite the stored data with the new data (day, hour, minute, channel) as described in the "Command
programming" section.
""
3.
Press the
button. The modified command is stored and the clock returns to normal operation.
Reading the display
In its default position, the display shows the current time and weekday. The lower part shows following information for CH1 (left side)
and CH2 (right side):
Program Type:
:
Operates following the stored programming and each channel will be ON or OFF depending on the program.
[ON]:
CH1 (left side) or CH2 (right side) is permanently ON
[OFF]:
CH1 (left side) or CH2 (right side) is permanently OFF
:
Manual triggering of the switch for both channels independently. If it was ON, it will switch to OFF and vice versa.
In this position, the stored programme will not be followed until the next command is reached.
RND:
Random operation programme
50.0048.02.00
""
button. The clock now displays the current time and sate.
""
.
www.audiovias.com
MRP2
3/7
Publicidad
Tabla de contenido
