BH FITNESS Nevada Plus G119X Instrucciones De Montaje página 25

FITTING THE LEG SUPPORT.-
11.-Take the leg support (15) and
insert it inside the seat tube Fig.9, in
the direction of the arrow.
Take the adjustment knob (42) and by
lining up the holes in the two tubes,
turn it clockwise to tighten securely.
FITTING THE SEAT.-
12.-Take the seat (24) and position it
on the seat support Fig.9.
Fit the bolts (91) with their washers
(84) and tighten securely.
FITTING THE BACKREST.-
13.-Take the
position it against the central mast, as
shown in Fig.10.
Now use the bolts (91) and washers
(84) to secure the backrest Fig.10.
FITTING THE BOTTOM FOAM
COVERS.-
14.-First take the foam covers (64)
and fit them onto the top rounded
tubes for the leg support Fig.10, then
take the end covers (53) and fit them
onto the ends of the rounded tube.
Now do the same for the bottom leg
support foam covers (63).
FITTING THE PANELS.-
15.-Position the
protection plates (26 and 27) onto the
main frame (4), fitting the plate wedge
into the accommodating groove in the
base, then tighten screws (70) slightly
in the upper part as shown in Fig.11.
FITTING THE WEIGHTS.-
16.- Fit the guide post (7) along with
washers (23) and the bottom weight
stops (59) as shown in Fig.12.
backrest (25)
left and
17.- Next, place the weights onto the
guide post as shown in Fig.12, in
correct alphabetical order with the
letters facing the front of the machine,
beginning with the letter "L".
18.- Now take the weight selector tube
(22), Fig.12, and attach the holding
collar (33) for the first weight and
insert the lockpin (32).
Fit the last weight (30) onto the bars.
Fit the spacers (94) and by inserting
the bushes (95) tighten the bolts (76)
for the guide post (7) to the main body
(4), as shown in Fig.12.
and
FITTING THE CABLE
SYSTEM.-
19.- First check that the steel cables
are correctly fitted into the pulleys that
are supplied prefitted, following the
arrows in Fig.13.
Fit the plates (18) onto the pulleys
(45) as shownh in Fig.13A.
Position the upper body cable (47)
onto pulley (46) Fig.13B, insert the
pulley into the main body support (4),
Fig.13B, and tighten using bolt (75),
washer (85) and nut (91).
Next, attach one end of cable (49)
to the left arm plate for the Butterfly
exercise, Fig.13C, fit bolt (74) with
right washers (85) and nut (91).
Do the same with the other end of
cable (49) for the right Butterfly
exercise arm.
The weights have already been
fitted into their housing in the previous
assembly step. Lift the first weight (30)
and fit the weight selector post (22),
as shown in Fig.13D.
Screw bolt (47A) into the selector post
(22), when it is screwed in, lower the
weight so that it rests on the other
weights.
25