Zodiac VVR-4.3INC Manual Del Usuario página 13

1. Fix the bracket of the video indoor monitor on the wall with screws (Picture 1).
2. Hang the monitor on the bracket after finishing the wire connection. Plug the enclosed
adapter into the sockets of AC power and the monitor (Picture 2).
B: Vertical Installation
1. As shown in Picture 1, insert support chip into the slot of base.
2. As shown in Picture 2, use two screws to fix support chip.
3. Insert main unit into the support chip (Picture 3).
5. Outdoor Camera Installation
1. Take out the screws located at the bottom of the outdoor camera (picture 1), and take
apart the bracket.
2. Take out the four screws in the back cover, and then take apart the front cover (Pic. 2).
3. Take off the name plate for marking family name or room name, and then fix the screws
of the back cover (Picture 3).
4. Install the outdoor camera at a height of 1.4m-1.7m, and make sure it avoids the direct
sunshine or rain (Picture 4).
5. Fix the bracket of the outdoor camera on the wall by tightening screws，and then fix the
screws at the bottom of the outdoor camera (Picture 5).