Rename Your Sources; Select Country; Select Menu Language; Teletext Language - IKEA UPPLEVA Manual Del Usuario

 Depending on how your network is
configured, you may be able to connect
your TV to your home network by
connecting the LAN port on your TV
directly to a network wall outlet using
a network cable. Note that the wall
outlet must be connected to a modem or
router elsewhere in your house.
Follow these steps to set up your
connection. Use /
through the menu or go through the options
and press OK to enter submenus.
1. Press MENU on the remote control to
enter the menu. Navigate to Options
>Network settings > Internet
connection and select On.
2. Go to Interface and choose Ethernet.
3. Select Connection test and press OK
to check the internet connectivity. If it
does not work, follow the next step.
4. Select Options > Network settings
> IP setting and press OK to enter
the IP setting menu. You can set
Address type to Auto if you want the
TV to acquire and enter the needed IP
address automatically, or Manual if you
want to enter your IP address manually.
Use / to move from one entry field
to another and enter the IP address,
Subnet mask, Default gateway,
Primary DNS and Secondary DNS
values using the number buttons.
5. If you want to see information about
your current connection, such as
Interface, Address type, IP address,
etc., select Options > Network
settings > Information and press OK.

Rename your sources

You can name your connected sources
according to the type of device instead of
the type of socket. To do so follow these
steps.
1. Press MENU on the remote control and
select Setup > Input settings.
2. Press OK to enter Input settings.
3. Press / to select the socket your
equipment is connected to.
4. Press / to select the type of device
attached to this socket.
5. Press MENU to return to the Setup
menu.
/ / to navigate

Select country

To select which country you are in, follow
these steps.
1. Press MENU on the remote control and
use / and OK to select and enter
Setup.
2. Use / to navigate to Country.
Press to select country. Here you will
be asked to enter the password. The
password is 1234, unless you have
changed it (See Password, later in this
chapter). When you have entered the
password you will be able to switch
between the countries using / . Press
MENU on the remote control to return
to the Setup menu.

Select menu language

You can choose your preferred menu
language by following these steps.
1. Press MENU to display the main menu.
2. Press / to select Setup and press OK
to enter.
3. Select Language and press OK to enter.
4. Press / to select your desired
language.
5. Press EXIT to close the menu.

Teletext language

If your language is not correctly displayed
in teletext, press MENU on the remote
control and select Options > Teletext >
Default language. Select your language or
language group using / .
You can change your default language
if your broadcaster provides a choice of
languages. To choose another language
press MENU on the remote control and
select Options> Teletext > Digital
teletext language and select language
using / . Press MENU to return to the
main menu or EXIT to leave the menu.
Press MENU to return to the main menu or
EXIT to leave the Teletext menu.

Using subtitles

You can enable subtitles for each TV
channel. Subtitles are broadcast via Teletext
or DVB-T/DVB-C digital broadcasts. With
38