Instructions For Use; How To Use The Steam Bath Set; Initial Operation; How To Proceed - HOESCH SteamBox 330 Instrucciones De Montaje

Use
Note:
Children can use this product only dunder supervision or if they receive appropriate instructions,
to allow the child to use the device safely and understand the danger of improper using!

04.01 How to use the steam bath set

1 - Unit ON / OFF
2 - Steam ON / OFF
3 - Water level
LED not illuminated – water level min. has not been reached
LED flashes – water level min. Has been reached
LED illuminated – water level max. has been reached

04.02 Initial operation

A precondition for initial operation is correct installation in accordance with the installation instructions.
On initial start-up (for new units and after deliming) max. 3 l of water can be filled. Each time it is refilled, max. 3 l of water
can be filled.

04.03 How to proceed

1. Switch unit on.
2. Fill up with water manually via the filler neck – max. 3 l.
3. LED lamps indicate the water level in the unit.
When overfilled, hot water flows into the cabin
with the steam. This can cause scalding!
4. Press steam on.
5. After heating (time required depends on fill quantity), steam pours into the cabin through the steam nozzle.
6. You can now enter the cabin.
7. Be careful about direct skin contact near the steam outlet.
8. Be careful when removing the sealing cap and when refilling the unit; the unit will still be hot if it
has been used immediately beforehand.
9. To finish your steam bath, switch the unit off.
GB
15