BEAUTY JATA MP34B Instrucciones De Uso página 13

BEGINNING THE CUT
• Relax and work slowly. Make short cuts. Do not go on to the final cut of one side or the back straight away.
Work gradually and all over the surface.
• It is better to cut a little each time to be able to cut some more later on.
• Comb the beard or the moustache before start cutting. It is better to cut the hair when it is dry, not wet. It is
easier to see and control the amount of hair you are cutting.
TRIMING BEARD
• Always remember you must begin with the cutting guide set to the longest cutting position before setting it
in the lower position.
• Start by cutting from the down side of the chin and moving the clipper with soft movements upwards and
outwards.
• For the final touches and the edges always use the hair clipper without any guide.
REVIEW OF THE MOUSTACHE
• Comb the moustache downwards.
• Start with the guide in its longer position. Later you may use the shorter cutting guides.
ROTARY SHAVER
• Insert the accessory (1).
• This accessory allows an accurate shaving and for using it, the hair must be short, if not, first, use the blade (3).
• Slide smoothly by making small circular movements around the face and pressing softly.
• The heads are moving in four directions to make easier the shaving in the most difficult areas.
BODY TRIMMER
• Use the body shaver (2).
• Before depilation, the skin must be dry and clean, free of oil or cream.
• Pass your hand over the depilation area in the contrary way to the growing hair to lift up the shorter hair.
• Cut the hair in the opposite direction of its growth.
NOSE ACCESSORY
• Place the accessory (4) in the main unit. Insert the groomer into the nostril and rotate in a circular motion.
• In both cases do not insert the unit more than 0,5 cm.
THE FINAL TOUCHES
• Do not use the guide for the final touches.
• To get an exact and straight cut of the sideburns, neck, moustache and beard and the area around the ears,
turn the hair clippers round and place them at a straight angle with your head so the blade is in slight contact
with the skin, and shave downwards. This way you will get a perfect finishing.
MAINTENANCE AND CLEANING
• Before doing anything, make sure the hair clipper is unplugged from the mains.
• For a correct cleaning remove the cutting guide. Clean with the brush (8), the cutting guide, the blade and the
other accessories. You can clean it under the tap, it is IPX5 water resistant (Fig. A).
• Use a slightly damp cloth to clean the outside of the appliance.
• Do not use in cleaning chemical products or abrasives, metallic scourers and similar, which may deteriorate
the surfaces.
BLADE REPLACEMENT
• To replace the blade, pull the blade upwards (Fig. B).
• To replace the new blade fit it by the lower part (Fig. C) and press on the top to leave it correctly fixed.
ENVIRONMENT PROTECTION
• Dispose the appliance according to the local garbage regulations.
• Dispose the batteries according to the local garbage regulations.
• Never throw away the appliance or the batteries to the rubbish. So you will help to the improvement
of the environment.
• The batteries must not be mixed with other domestic residues
13