Adjusting The Airflow Direction - Airwell IU-MINV-HW-9H Manual De Instrucciones

1. Horizontal
CAUTION
2. Vertical
A. Sweep function
The flap starts moving up and down to
deliver air over the sweep range.
NOTE
CAUTION
OI-757-23EG

Adjusting the Airflow Direction

The horizontal airflow can be adjusted by moving the vertical vanes with
your hands to the left or right.
When the humidity is high, the vertical vanes should be in the front
position during the cooling or dehumidifying operation. If the vertical
vanes are positioned all of the way to the right or left, condensation may
begin to form around the air vent and drip down.
The vertical airflow can be adjusted by moving the flap with the remote
control unit. Do not move the flap with your hands. Confirm that the
remote control unit has been turned on. Use the FLAP button to set either
the sweep function or one of the six airflow direction settings.
B. Setting the airflow manually
• The flap automatically closes when the unit is off.
• During the heating operation, the fan speed will be very low and the
flap will be in the horizontal position (position 6 ) until the air being
blown out of the unit begins to warm. Once the air warms up, the flap
position and fan speed change to the settings specified with the
remote control.
• Use the FLAP button on the remote control to adjust the position of
the flap. If you move the flap by hand, the factual flap position and the
flap position on the remote control may no longer match. If this
should happen, shut off the unit, wait for the flap to close, and then
turn on the unit again; the flap position will now be normal again.
• Do not have the flap pointed down during cooling and drying
operation. Condensation may begin to form around the air vent and
drip down.
SWEEP
COOL
and
DRY
SWEEP
HEAT
Referring to the above illustration, use the
FLAP button to set the airflow direction
within the range used during the heating,
cooling, or dehumidifying operation.
23