hi-Fun hi-Tube2 Bluetooth Manual Del Usuario página 14

Switch on hi-Tube2 Bluetooth®.
To switch on hi-Tube2 Bluetooth® hold the button until
transparent fins turns on and hi-Tube2 Bluetooth® emits
4 acustic tones. Afterwards hi-Edo automatically connects
itself to the last paired device, if available, and the warning
LED flash slowly in blue to confirm the connection. If there
is no available paired device or if it is out of range, hi-Tube2
Bluetooth® turns off in about 7 minutes in order to prevent
battery from discharging.
Pair hi-Tube2 Bluetooth® with a compatible
device.
To pair for the first time, pair for a second time or to pair to a
different device, hi-Edo must be set in pairing mode, signaled
by the transparent fins flashing alternately and quickly red
and blue. To activate the pairing mode you need to switch
off hi-Tube2 Bluetooth® and switch it on again holding the
button until the transparent fins flash alternately red and
blue. Now you can select hi-Tube2 Bluetooth® from the list of
found devices on your device. As soon as the device is paired,
the transparent fins flash slowly blue.
Now it is possible to listen to music and to make calls* through
hi-Tube2 Bluetooth® (*thanks to the integrated microphone).
It is also possible to pair hi-Tube2 Bluetooth® to 2 devices at
the same time. To do this, pair the first device as explained
before, then repeat this step with another devices. At this point
the two paired devices could be connected at the same time
and priority is assigned to the last device that start streaming
to hi-Tube2 Bluetooth®.