Troubleshooting Guide - EINHELL GE-CR 30 Li Manual De Instrucciones Original

11. Troubleshooting guide

Fault
Motor does not start
Motor performance
drops
Notice! For protection, the motor is equipped with a thermal switch which cuts out when the
motor is overloaded and switches on again automatically after a short cooling period.
Anl_GE_CR_30_Li_SPK7.indb 24 Anl_GE_CR_30_Li_SPK7.indb 24
GB
Possible causes
- Safety plug is not inserted
- Battery is not correctly inserted
- Motor terminals or capacitor dis-
connected
- Excessive working depth
- Battery empty
- Soil too hard
- Blades badly worn
- 24 -
Remedy
- Insert the safety plug (see 6.)
- Remove the battery and reinsert
(see 5.)
- By customer service workshop
- Reduce the working depth
- Charge the battery (see 5.)
- Correct working depth
- Replace hoe blades
19.02.2019 10:39:42 19.02.2019 10:39:42