Switching The Machine O; Emptying The Catch Basket - Intimus FlashEx Instrucciones De Uso

GB
NOTE!
While shredding, repeated reversing (swit-
ching between forward and backward ope-
ration) is normal. This is part of the shredding
process and does not indicate a failure.
Smart shredding function
The intimus FlashEx has a smart shredding function.
When a device is fed into the machine, it is possible
the cutting rollers do not immediately grip the device.
In this case the machine reverses automatically. This
brings the material to shred into a new position.
This sequence can happen up to ve times in successi-
on. As soon as the cutting rollers grip the device, they
start shredding it.
If after ve sequences the cutting rollers cannot grip
the device, the cutting mechanism stops (see „Failure",
p. 13).
"Cutting mechanism ready" / "Cutting mechanism
not ready" indicator
The curved pilot lamps (Fig. 1/9) show whether materi-
al can be fed into the machine or not:
Green light: machine is ready!
The cutting mechanism can be fed.
Red light: machine is busy!
The cutting mechanism is already working and
cannot be fed.
Stopping the shredding process manually
The shredding process can be manually stopped at any
time by brie y pressing the function button (Fig. 1/1)
or the reverse button (Fig. 1/5).
NOTE!
After 10 min without use the machine shuts
o automatically.

3.6 Switching the machine o

Press and hold the function button (Fig. 1/1) for about
3 seconds.
The machine turns o .
12
Translation of the Original Operation Manual
Übersetzung der Originalbetriebsanleitung

3.7 Emptying the catch basket

NOTE!
Please consult the appropriate recycling servi-
ces in your area to learn how to properly dis-
pose of the shredded material!
1
2
1
Door
2 Catch basket
Fig. 4 Catch basket
If the catch basket is full, the motor switches o . The
pilot lamp (Fig. 1/4) lights up. The curved pilot lamps
(Fig. 1/9) ash.
Proceed as follows to empty the catch basket (Fig. 4/2):
1. Open the door (Fig. 4/1).
The pilot lamp (Fig. 1/6) lights up.
2. Remove the catch basket with the full bag.
The pilot lamp (Fig. 1/4) goes out.
3. Pull the bag out to its full length, tie it up and seal
it with adhesive tape or cable ties.
4. Remove the bag and dispose of it with the con-
tents.
5. Insert an empty bag in the basket.
6. Insert the basket back into the machine.
7. Close the door.
The pilot lamp goes out.
The machine is ready for operation.
NOTE!
The machine only runs if the door and the sa-
fety glass are closed!
000085
93902 1 01/16