Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Mounting Cutting Discs
To fit a cutting disc, proceed as follows:
1.
Make sure the grinder spindle is at standstill.
2.
Locate the lock plate onto the machines spindle.
3.
Locate the disc against the lock plate.
4.
Screw the lock nut onto the spindle.
5.
Push the spindle lock button to the lock spindle and tighten the lock nut with the
two-pin wrench supplied.
NOTE
For cutting, while using a depressed center disc, use the machine at an angle of
90 to cut the target surface.
1English1
English
-11
Publicidad
Tabla de contenido
