Hints And Tips - PURE CHRONOS iDOCK II Serie Manual De Instrucciones

Hints and tips

The message on screen says 'No stations available'
DAB reception is not strong enough to receive any stations. Check that your aerial is fully
uncoiled and use Autotune (page 5) to search for stations. Try adjusting your aerial and radio
position.
The screen is very dark
Check the Display settings (page 11).
The on-screen clock does not appear
If you disconnect the unit from the mains whilst listening to your iPod and then plug it in
again, you may need to change the audio source to DAB or FM so that the time can be
acquired from the signal.
The bass/treble on iPod/iPhone tracks is too high
Check the bass and treble controls on the iPod/iPhone.
The volume control on the iPod/iPhone does not affect the volume level
When your iPod is docked, the volume level must be adjusted on the unit, not the iPod.
Do not turn up the iPod volume, it should be left at the volume level you normally use for
portable listening.
Tone alarm safety net
If you set an alarm to 'iPod' mode but then forget to insert your iPod into the dock before the
alarm time is reached, the tone alarm will sound instead.
Resetting your Chronos iDock
Resetting your radio removes all presets, stored stations and alarm settings and resets all
options to defaults. To reset:
1. Press the Menu button and select 'Factory reset'.
2. Choose 'Yes' and push the Navigation dial to confirm the reset.
Trim stations
Unavailable DAB stations are indicated by '?' before the station name (e.g., ?Rock radio)
To trim unavailable stations:
1. Press the Menu button then scroll to and select 'Trim stations'.
2. Choose 'Yes' and push the Navigation dial to confirm.
12