Tabla De Contenido; General Precautions - Pentair SOFTFLO 5600 Manual De Servicio

TABLE OF CONTENTS
GENERAL PRECAUTIONS ........................................................ 3
INSTALLING WATER SOFTENERS ON WATER SUPPLIES
CONTAINING IRON ................................................................... 4
LOCATION SELECTION ............................................................ 4
ELECTRICAL SPECIFICATIONS ............................................... 4
EQUIPMENT INSTALLATION .................................................... 5
PRE-INSTALLATION CHECKLIST ............................................ 6
INSTALLATION ......................................................................... 6
PIPING DETAILS ....................................................................... 7
DRAIN REQUIREMENTS .......................................................... 7
MODEL 5600 INSTALLATION AND START-UP PROCEDURES . 8
TIMER FEATURES .................................................................... 9
TIMER OPERATION .................................................................. 9
MASTER PROGRAMMING MODE CHART ................................ 11
MASTER PROGRAMMING MODE ............................................. 12
USER PROGRAMMING MODE .................................................. 15
DIAGNOSTIC PROGRAMMING MODE ...................................... 16
ADJUSTING THE EFFICIENCY ................................................. 17
DISINFECTION OF WATER SOFTENERS.................................. 18
ADDING SALT ........................................................................... 18
SYSTEM ASSEMBLY ................................................................. 20
CONTROL VALVE DRIVE ASSEMBLY ........................................ 21
CONTROL VALVE ASSEMBLY ................................................... 22
TROUBLESHOOTING ................................................................ 23
SERVICE INSTRUCTIONS ......................................................... 25
WATER CONDITIONER FLOW DIAGRAMS ............................... 27
MAINTENANCE AND REPAIR .................................................. 29
GENERAL PRECAUTIONS (4002217 & 4002162)
• The equipment should not be used by people
(including children) with physical, sensorial or
mentally reduced capabilities or with lack of
experience or knowledge, unless they receive
supervision or training.
• Children must be supervised so that they do not play
with the equipment.
•
The device is designed to be connected to the
water inlet of the supply network and should not be
connected by a hose.
Before you begin insttallation, read the entire manual. Gather
all materials and tools needed. Improper installation voids
warranty.
Do not use with water that is
NOTE:
microbiologically unsafe or of unknown
quality without adequate disinfection
before or after the softener.
SODIUM INFORMATION: Water softeners
using sodium chloride for regeneration will
add sodium to the water. Persons who are on
sodium-restricted diets should consider the
added sodium as part of their overall sodium
intake.
NOTE: Sodium Chloride or Potassium Chloride are
recommended.
NOTE: The efficiency of these softeners shall specify validity
only at the stated salt dosage.
A qualified plumber should be contracted to make all difficult
piping installations.
Softener must be protected against freezing, which
CAUTION
can cause cracking of the softener and water
leakage.
Do not filter water over 110°F (43°C) because hot
CAUTION
water will damage softener and void warranty.
Locate softener within 20 feet (610 cm) of drain.
CAUTION
Drain must be capable of handling a maximum
backwash flow rate of 5 gallons (19 liters) of water
per minute.
NOTE: Some states and/or counties have restrictions when
connecting the drain line to a septic system. Check
with your local authorities first.
Maximum allowable inlet water pressure is 125
CAUTION
psi 0.86 MPa (8.5 bar) [if daytime pressure is over
100 psi 0.69 MPa (6.8 bar), nighttime pressure may
exceed the maximum]. Use a pressure-reducing
valve if necessary.
NOTE: Handle softener with care. Do not turn upside down,
drop, or set on sharp objects.
NOTE: The softener requires a minimum inlet water flow of
5.0 gpm at 30 psi 0.21 MPa.
NOTE: If you are on a private well system, check minimum
water pressure with an accurate gauge. (Gauges on
older water systems are often inaccurate). Pressure
that is less than 30 psi 0.21 MPa may cause low flow
rate and inadequate regeneration.
When connecting your unit, take note that the
CAUTION
inlet, outlet, and drain connections are made in
accordance with state and local plumbing codes.
Do not over-tighten pipe to piping boss.
CAUTION
Due to some homes using piping as a source of
CAUTION
electrical grounding, a grounding strap must be
installed. Consult your local dealer.
Do not heat piping if it is in contact with the control
CAUTION
valve.
NOTE: Do not put excessive force on the inlet/outlet drain
connections of the control valve.
NOTE: Do not use pipe joint compound or plumber putty when
threading pipe into the piping boss. Use only plumber
tape.
PENTAIR SOFTFLO 5600 Service Manual • 3