switel TV-L2BT Manual De Instrucciones página 21

• Standby time: up to 180 hours (when the receiver is connected to a
device but not playing any sound)
• Auto off: when the receiver is turned on without any connection to
Bluetooth devices, it will be turned off after 5 minutes. To turn on the
receiver again, you should first slide the power button to the "OFF"
position. Then slide it back to "ON" again.
• After Auto off: if the power button is not slided to "OFF" the battery can
last up to 1.5 months.
OPERATION
Hearing damage due to high volumes!
This receiver allows you to set higher volumes than conventional
headphones. This can cause hearing damage in persons with healthy
hearing and especially in children.
• Before putting the receiver on, set the volume on the receiver to a low
value.
• Do not continuously expose yourself to high volumes.
1 Power on the transmitter. Switch on the audio source. The blue indicator LED
on the transmitter will flash.
2 Switch the On/Off switch on the headset receiver to ON position, then the blue
LED indicator will flash. The transmitter and the headset receiver will then be
connected automatically. If transmitter and headset receiver are not connected
with each other, press and hold the "PAIR" button on the receiver for about 5
seconds, the blue LED flashes quickly and the units will be connected.
3 Flex the head set arms outwards until the ear buds can be inserted in the ear.
Please note the ear buds can be angled through a movement up, down or
sideways, so as to enter the ear a little deeper. This will improve the sound quality
and volume. Gently press the ear buds further into the ear to find a comfortable
position for the ear buds and an ideal position for the sound.
4 Adjust the desired volume.
5 Adjust the tone clarity setting if necessary.
To set the tone clarity briefly press the TONE button repeatedly.
19